Hi folks -
The only place around here where I can see an Epson 2450 is CompUSA
and those clerks know jack. I asked to see a manual and no go either.
Criminy. Anyway, I was looking at the transparancy/negative carrier
and trying to figure out how it worked. There may have been a piece
that wasn't on display. What I saw saw was a bracket with a
wavy-edged slot for sliding a negaitive strip into, and then 4 or 5
6x6cm or 2x2" cutouts in the same piece, I assume for slides and MF
negatives. But how would you feed a strip of 6x6 negs? Do they have
to be cut into individual frames? Or hold a slide in for that matter?
I'm not exactly sure of the size of the cutouts, whether it was 2x2
for slides or 2 1/4 x 2 1/4 for MF. The cutouts didn't have a lip to
hold a the mounted slide in postion, nor did they look they were set
up for a snap fit.
Any illucidation welcome, thanks.
Ken Durling
Visit my new easier-to-browse PhotoSIG portfolio:
----------------------------------------------------------------------------------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or
body
