Okay, I'll try your test and let you know...
Tom
-----Original Message-----
From: filmscanners_owner@halftone.co.uk
[mailto:filmscanners_owner@halftone.co.uk]On Behalf Of Arthur Entlich
Sent: Tuesday, February 11, 2003 12:59 AM
To: TMaugham@yahoo.com
Subject: [filmscanners] Re: SS4000 Slide holders
Could you try placing a slide in each compartment and allow it to sit
for some hours or overnight and see if the plastic springs survive
without cracking?
As you likely know, there were a group of the SS4000-SS4000+ slide
carriers produced which were defective. It was likely cold molding or
contamination with release agent, or whatever, but the problem is that
the spring clips can and did fail on one production run. Why this guy
(who lives in Mass, where Polaroid in located) has all these carriers,
when Polaroid has had shortages, would make an interesting question...
He's been selling theses for a while now...
Art
Thomas Maugham wrote:
> Here's a good deal on slide holders for the SS4000 and SS4000 plus. Will
> probably fit the Microtek 4000t and 4000tf as well.
>
>
>
> I'm not the seller, just passing on information. I bought 3 of them "just
in
> case"...
>
> Regards,
>
> Tom
>
----------------------------------------------------------------------------
------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title
or body
----------------------------------------------------------------------------------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or
body
